Audi 80/Avant (B4)

Audi 80/Avant
The description
System of release of the fulfilled gases
Cooling system
Fuel tank and the fuel pump
The air filter and intake channels
Injection system
Transmission and transmission
- Suspension bracket and steering
   The control of a condition of a casing of the steering mechanism
   Check of dustproof covers and backlash tips of cross-section steering draughts
   Check of dustproof covers of hinges of a forward suspension bracket
   Check backlash a steering
   Check wedge or semi wedge a belt
   Check of level of a working liquid
   Check backlash the bearing of a nave of a wheel
   The list of malfunctions
   Adjustment of corners of installation of wheels
   Measurement of adjustment of corners of installation of wheels
   The list of malfunctions
   Running gear and steering repair
   Repair of a forward suspension bracket
   Repair of a back suspension bracket
   Steering repair
   The list of malfunctions
   Adjustment of the steering mechanism
   Refuelling by a liquid and prorolling of hydrosystem of the amplifier of a wheel
   Safety pillow
   Safety precautions requirements
Brake system
Antiblocking system of brakes
Wheels and tyres
body electrosystem
Ignition system
Signalling devices
Devices and auxiliary devices
Heating and ventilation
Body elements
Search of malfunctions

Steering repair

Check on tightness of the steering mechanism with the amplifier

If in a receiver the lowered level of a liquid it is necessary to check up all system of the steering mechanism as soon as possible is found out. Otherwise the amplifier of the steering mechanism can suddenly stop work during movement. The sequence of check is more low resulted:


  1. To turn out a steering wheel once to the right and once on the left against the stop. Thus in the wheel hydraulic booster the highest possible pressure is formed, and not tight places become more appreciable.
  2. To leave a steering wheel in one of extreme positions and to check up following places on негерметичность:
  3. The rotornyj valve. It is located approximately there where the steering column incorporates to the steering mechanism. The working liquid in this case acts in car salon under a control panel on a forward wall.
  4. Подтекание on a sealing lining gear рейки or a sealing lining in the left tip. For check to weaken clips of a casing and to shift it aside.
  5. On the hydraulic pump. For revealing негерметичности, probably, before check it is necessary to wash the engine.
  6. On connections of pipelines. It is necessary to check up and if necessary дозатянуть all connections separately.

Клиновой and полиwedge belts

In more details about клиновом or поликлиновом a belt of the hydraulic pump you learn the Generator in section.